[ovirt-users] Re: Network configuration for self-hosted engine deployement oVirt node 4.2
What you did looks fine but please take care that bonds should be
named
bondX where X is [0, 1, 2...].
I remember using 'bond-admin', 'bond-infra' for the name of my bonding via
nmtui on my previous test. I keep this in mind for my future deployment.
Please note then that not all the bonding modes could be used for VMs
and
the engine VM should reach the hosts over the management network:
https://www.ovirt.org/documentation/admin-guide/chap-Logical_Networks/#bo...
Good point! I am pretty sure I was using Round Robin for the admin and XOR for the infra.
The admin (ovirtmgmt) cannot be RR, I will also check that.
Thank you for your feedback @Simone!