Hi, thanks for the response.. I have only worked with the GUI on the host so far, but I am will watch this and also the previous posters pointer - I will obviously have to start working with the hosts and config files sooner or later and I have worked with Linux for many years, so should be too hard to get rolling, thanks again. -----Original Message----- From: Itamar Heim [mailto:iheim@redhat.com] Sent: 10 September 2014 11:40 To: Bill Dossett; users@ovirt.org Subject: Re: [ovirt-users] Question on network and boding I think! On 09/10/2014 01:23 PM, Bill Dossett wrote:
Hi - I am a complete newb at Ovirt, but have setup my Ovirt manager and a host and connected them together.
I am basically looking to replicate in my lab with Ovirt what a simple VMware installation is doing.
I would like a single network or in vmware terms a vswitch, with two network cards in the node, both connected to trunked ports so that I can create port groups with different vlans, one for management, and one for VMs and possibly a DMZ vlan.
I have tried bonding the network interfaces, but there is also a bridge option and I don't know what that does. I have read the ovirt docs on bonded interfaces and they are a little bit terse to actually get me started on this.
bonding them where? from the hosts or from the gui? https://www.youtube.com/watch?v=3EMrqQR-f3w (around 1:30 minutes from start)
If there is a better guide, or simple explanation to get me over this hurdle I would appreciate it. Sorry for all the vmware terms as well, but I have worked with vmware for many years and it's the only virtual environment I know really well - but with their pricing models, I really need to start looking around now!
Thanks very much!
*Bill Dossett*
*Virtualisation Architect*
*Pitney Bowes - Tech Central***
6 Hercules Way, 600 Leavesden Park
Watford, WD25 7GS
Phone(+44) (0)1923 279353 | VOIP: 54739353
Mobile(+44) (0)7775 908612
bill.dossett@pb.com <mailto:bill.dossett@pb.com>
www.pb.com <http://www.pb.com/>
*In Engineering?**Raise a ticket via Remedy Anywhere [HERE <http://teamsite.inside.pb.com/sites/TCPPM/GES/Lists/Create%20Incident /newIncident.aspx>]takes less than a minute*
*ManageIQ User Guide available*[*HERE <https://dl.dropbox.com/u/6219441/ManageIQ%20-%20User%20Manual%20PB%20 v4.pdf>*]
*Check out the ManageIQ Blog for recent enhancements and information [HERE] <http://teamsite.inside.pb.com/sites/TCPPM/GES/manageiq/default.aspx>*
---------------------------------------------------------------------- --
_______________________________________________ Users mailing list Users@ovirt.org http://lists.ovirt.org/mailman/listinfo/users
________________________________