Re: [Users] Gluster network info

On Fri, Oct 4, 2013 at 12:15 PM, Sahina Bose wrote: I tried and it works. I was able to maintain my data too. I stopped the only VM created and put both hosts in maintenance. Then from f18ovn01 (with 10.4.4.58 on ovirtmgmt and 192.168.3.1 on new replication network): please note f18 in the name but is fedora 19.... gluster volume stop gvdata gluster volume delete gvdata gluster peer detach 10.4.4.59 change /etc/hosts on both hosts and activate another interface with 192.168.3.1 and 192.168.3.3 to clear data about previous gluster volume and reuse it with same values: on both hosts setfattr -x trusted.glusterfs.volume-id /gluster/DATA_GLUSTER/brick1 setfattr -x trusted.gfid /gluster/DATA_GLUSTER/brick1 rm -rf rm -rf /gluster/DATA_GLUSTER/brick1/.glusterfs gluster peer probe f18ovn03.mydomain remake the manual steps to create gvdata volume and settings as before from oVirt webadmin activated both hosts and all came up transparently. able to start c6s VM (from run once only due to bug...) wget a netinst.iso for fedora 19 from inside VM and during transfer (VM is running on this f18ovn01 node): [root@f18ovn01 ]# bwm-ng v0.6 (probing every 1.000s), press 'h' for help input: libstatnet type: rate | iface Rx Tx Total ============================================================================== ovirtmgmt: 0.19 KB/s 0.24 KB/s 0.43 KB/s enp3s0: 214.34 KB/s 28794.59 KB/s 29008.93 KB/s ------------------------------------------------------------------------------ total: 214.53 KB/s 28794.82 KB/s 29009.35 KB/s Also restarted ovirt-engine service on engine. Note that from engine point of view when I go in volumes --> gvdata --> bricks, still I see 10.4.4.58 and 10.4.4.59, probably because for the engine those are the ip addresses of f18ovn01 and f18ovn03 nodes.... Or I don't know if it wrote anywhere in the db the gluster data or only gets them dinamically Gianluca