12:21 p.m.
I am now able to reproduce the problem where network profile definitions are lost on VM
edit.
- Create VM
- From the "Network Interfaces" tab, click on "New" and assign the
ovirtmgt profile to nic1
- Edit VM, from the "nic1" drop down select another profile and click OK
- Edit the same VM again and nic1 lists as <Empty>
I upgraded to 3.3.2-1.el6 and still see the problem.
As ever, any help is very much appreciated.
Thanks,
Simon
-----Original Message-----
From: users-bounces(a)ovirt.org [mailto:users-bounces@ovirt.org] On Behalf Of Simon Barrett
Sent: 12 December 2013 21:53
To: Lior Vernia
Cc: users(a)ovirt.org
Subject: Re: [Users] Network profile lost after host edit
Lior,
I'm running 3.3.1.
I think it may be related to how I created the VM's. Another VM created using the
blank template works fine and the network config displays correctly when I click on edit.
The problem VM's were created with a different template. I'll dig a bit further to
see if I can narrow it down any further.
I don't have to click show advanced to exhibit the problem.
Thanks for the response
Simon
On 12 Dec 2013, at 16:44, "Lior Vernia"
<lvernia(a)redhat.com> wrote:
Hi Simon,
I apologize for the delay in my response. I've worked quite a bit on
that part of the dialog since oVirt 3.3, and while it was quite buggy
I haven't encountered this exact issue you're describing. It does
remind me of one bug though; could it be that pressing the "Show
Advanced Options" is what triggers the strange behavior?
What version of oVirt engine are you running? Both 3.3.1 and 3.3.2
should be quite stable as far as this dialog is concerned, so
upgrading might be a good idea.
As for workarounds, it sounds like a GUI issue so I don't think
there's anything you can do apart from upgrading the engine.
Yours, Lior.
> On 11/12/13 13:40, Simon Barrett wrote:
> I have a problem where VM network profiles are lost when editing a host.
> E.G.
>
>
>
> * VM is running fine on the correct network. Network Interfaces
> tab shows "nic1" and "Network Name" shows the correct network
profile.
>
> * I shutdown the VM then right click and Edit.
>
> * The General settings for the node shows "nic1 <Empty>". If
I
> then edit config, something like increasing memory or changing CPU
> cores then click on OK, the VM configuration is saved without a network profile.
>
> * When I boot the VM I cannot connect to it.
>
> * I then have to edit the node again configure back in the
> correct network profile.
>
>
>
> Does anyone know if this is a known issue? If not, any suggestions as
> to how I correct this so that the original network profile definition
> is retained after an edit?
>
>
>
> Many thanks,
>
>
>
> Simon
>
>
>
>
>
> _______________________________________________
> Users mailing list
> Users(a)ovirt.org
> http://lists.ovirt.org/mailman/listinfo/users
>
_______________________________________________
Users mailing list
Users(a)ovirt.org
http://lists.ovirt.org/mailman/listinfo/users