Hi, @ Can also be low level issue in kernel, hba, switch, server. I have the old storage on the same cable so I don’t think its hba or switch related On the same Switch I have a few ESXi Server with same storage setup which are working without problems. @multipath I use stock ng-node multipath configuration # VDSM REVISION 1.3 defaults { polling_interval 5 no_path_retry fail user_friendly_names no flush_on_last_del yes fast_io_fail_tmo 5 dev_loss_tmo 30 max_fds 4096 } # Remove devices entries when overrides section is available. devices { device { # These settings overrides built-in devices settings. It does not apply # to devices without built-in settings (these use the settings in the # "defaults" section), or to devices defined in the "devices" section. # Note: This is not available yet on Fedora 21. For more info see # https://bugzilla.redhat.com/1253799 all_devs yes no_path_retry fail } } # Enable when this section is available on all supported platforms. # Options defined here override device specific options embedded into # multipathd. # # overrides { # no_path_retry fail # } multipath -r v3 has no output Thx Christian Von: Nir Soffer [mailto:nsoffer@redhat.com] Gesendet: Mittwoch, 08. Februar 2017 20:44 An: Grundmann, Christian <Christian.Grundmann@fabasoft.com> Cc: users@ovirt.org Betreff: Re: [ovirt-users] Storage domain experienced a high latency On Wed, Feb 8, 2017 at 6:11 PM, Grundmann, Christian <mailto:Christian.Grundmann@fabasoft.com> wrote: Hi, got a new FC Storage (EMC Unity 300F) which is seen by my Hosts additional to my old Storage for Migration. New Storage has only on PATH until Migration is done. I already have a few VMs running on the new Storage without Problem. But after starting some VMs (don’t really no whats the difference to working ones), the Path for new Storage fails. Engine tells me: Storage Domain <storagedomain> experienced a high latency of 22.4875 seconds from host <host> Where can I start looking? In /var/log/messages I found: Feb 8 09:03:53 ovirtnode01 multipathd: 360060160422143002a38935800ae2760: sdd - emc_clariion_checker: Active path is healthy. Feb 8 09:03:53 ovirtnode01 multipathd: 8:48: reinstated Feb 8 09:03:53 ovirtnode01 multipathd: 360060160422143002a38935800ae2760: remaining active paths: 1 Feb 8 09:03:53 ovirtnode01 kernel: blk_update_request: I/O error, dev dm-10, sector 8 Feb 8 09:03:53 ovirtnode01 kernel: blk_update_request: I/O error, dev dm-10, sector 5833475 Feb 8 09:03:53 ovirtnode01 kernel: blk_update_request: I/O error, dev dm-10, sector 5833475 Feb 8 09:03:53 ovirtnode01 kernel: blk_update_request: I/O error, dev dm-10, sector 4294967168 Feb 8 09:03:53 ovirtnode01 kernel: Buffer I/O error on dev dm-207, logical block 97, async page read Feb 8 09:03:53 ovirtnode01 kernel: blk_update_request: I/O error, dev dm-10, sector 4294967168 Feb 8 09:03:53 ovirtnode01 kernel: blk_update_request: I/O error, dev dm-10, sector 4294967280 Feb 8 09:03:53 ovirtnode01 kernel: blk_update_request: I/O error, dev dm-10, sector 4294967280 Feb 8 09:03:53 ovirtnode01 kernel: blk_update_request: I/O error, dev dm-10, sector 0 Feb 8 09:03:53 ovirtnode01 kernel: blk_update_request: I/O error, dev dm-10, sector 0 Feb 8 09:03:53 ovirtnode01 kernel: blk_update_request: I/O error, dev dm-10, sector 4294967168 Feb 8 09:03:53 ovirtnode01 kernel: device-mapper: multipath: Reinstating path 8:48. Feb 8 09:03:53 ovirtnode01 kernel: sd 3:0:0:22: alua: port group 01 state A preferred supports tolUsNA Feb 8 09:03:53 ovirtnode01 sanlock[5192]: 2017-02-08 09:03:53+0100 151809 [11772]: s59 add_lockspace fail result -202 Feb 8 09:04:05 ovirtnode01 multipathd: dm-33: remove map (uevent) Feb 8 09:04:05 ovirtnode01 multipathd: dm-33: devmap not registered, can't remove Feb 8 09:04:05 ovirtnode01 multipathd: dm-33: remove map (uevent) Feb 8 09:04:06 ovirtnode01 multipathd: dm-34: remove map (uevent) Feb 8 09:04:06 ovirtnode01 multipathd: dm-34: devmap not registered, can't remove Feb 8 09:04:06 ovirtnode01 multipathd: dm-34: remove map (uevent) Feb 8 09:04:08 ovirtnode01 multipathd: dm-33: remove map (uevent) Feb 8 09:04:08 ovirtnode01 multipathd: dm-33: devmap not registered, can't remove Feb 8 09:04:08 ovirtnode01 multipathd: dm-33: remove map (uevent) Feb 8 09:04:08 ovirtnode01 kernel: dd: sending ioctl 80306d02 to a partition! Feb 8 09:04:24 ovirtnode01 sanlock[5192]: 2017-02-08 09:04:24+0100 151840 [15589]: read_sectors delta_leader offset 2560 rv -202 /dev/f9b70017-0a34-47bc-bf2f-dfc70200a347/ids Feb 8 09:04:34 ovirtnode01 sanlock[5192]: 2017-02-08 09:04:34+0100 151850 [15589]: f9b70017 close_task_aio 0 0x7fd78c0008c0 busy Feb 8 09:04:39 ovirtnode01 multipathd: 360060160422143002a38935800ae2760: sdd - emc_clariion_checker: Read error for WWN 60060160422143002a38935800ae2760. Sense data are 0x0/0x0/0x0. Feb 8 09:04:39 ovirtnode01 multipathd: checker failed path 8:48 in map 360060160422143002a38935800ae2760 Feb 8 09:04:39 ovirtnode01 multipathd: 360060160422143002a38935800ae2760: remaining active paths: 0 Feb 8 09:04:39 ovirtnode01 kernel: qla2xxx [0000:11:00.0]-801c:3: Abort command issued nexus=3:0:22 -- 1 2002. Feb 8 09:04:39 ovirtnode01 kernel: device-mapper: multipath: Failing path 8:48. Feb 8 09:04:40 ovirtnode01 kernel: qla2xxx [0000:11:00.0]-801c:3: Abort command issued nexus=3:0:22 -- 1 2002. Feb 8 09:04:42 ovirtnode01 kernel: blk_update_request: 8 callbacks suppressed Feb 8 09:04:42 ovirtnode01 kernel: blk_update_request: I/O error, dev dm-10, sector 4294967168 Feb 8 09:04:42 ovirtnode01 kernel: blk_update_request: I/O error, dev dm-10, sector 4294967280 Feb 8 09:04:42 ovirtnode01 kernel: blk_update_request: I/O error, dev dm-10, sector 0 Feb 8 09:04:42 ovirtnode01 kernel: blk_update_request: I/O error, dev dm-10, sector 4294967168 Feb 8 09:04:42 ovirtnode01 kernel: blk_update_request: I/O error, dev dm-10, sector 4294967280 Feb 8 09:04:42 ovirtnode01 kernel: blk_update_request: I/O error, dev dm-10, sector 0 Maybe you should consult the storage vendor about this? Can be also incorrect multipath configuration, maybe multipatch checker, fail, and because you have one path the device moved to faulty state, and sanlock fail to access the device. Can also be low level issue in kernel, hba, switch, server. Lets start by inspecting multipath configuration, can you share output of: cat /etc/multiapth.conf multipath -r v3 Maybe you can expose one lun for testing, and blacklist this lun in multipath.conf. You will not be able to use this lun in ovirt, but it can be used to validate the layers below multipath. If a plain lun is ok, and same lun used a multipath device fails, the problem is likely to be multipath configuration. Nir multipath -ll output for this Domain 360060160422143002a38935800ae2760 dm-10 DGC ,VRAID size=2.0T features='1 retain_attached_hw_handler' hwhandler='1 alua' wp=rw `-+- policy='service-time 0' prio=50 status=active `- 3:0:0:22 sdd 8:48 active ready running Thx Christian _______________________________________________ Users mailing list mailto:Users@ovirt.org http://lists.ovirt.org/mailman/listinfo/users