Re: [Users] 3.1 and centos 6.3 problem
I could see that the volume (vol1) was mounted with nfs type.
I dismounted the volume and mounted it again in both nodes but using
glusterfs type.
This time, I could create a 10GB preallocated virtual disk.
The events tab showed:
2013-Feb-19, 09:12:39 Add-Disk operation of 'vm1_Disk1' was initiated on
VM vm1 by admin@internal.
2013-Feb-19, 09:30:35 The disk 'vm1_Disk1' was successfully added to VM vm1.
Too slow, isn't? but worked
El 19/02/2013 08:21 a.m., Fernando Ariel Martinez escribió:
I have installed ovirt 3.1 according to the instructions in
"Integrating
Gluster storage into oVirt" - by Robert Middleswarth, linked in
http://wiki.ovirt.org/Documentation.
I was able to complete the instructions successfully but I have problems
when a need to create a VM. Especifically when I need to allocate space
for the virtual disk.
I have:
1 ovirt engine server, (admin)
2 nodes, IBM System x 3650M3 (nodo1, nodo2)
1 switch cisco SG 300-20 (to connect them)
I created a VM (vm1).
When I add a 10GB preallocated disk to vm1, after a few seconds the
ovirt engine server loses the connection with the node SPM.
I can see in the events tab "Invalid status on Data Center Default.
Setting status to Non-Responsive."
Then, the SPM changes to the other node. At last, in the events tab I
can see "Operation Add-Disk failed to complete on VM vm1."
I have set SELinux in permissive mode. I have also disabled iptables.
In the ovirt engine server there are an ISO domain, called iso, (NFS
Export Path: admin.cluster:/nfs/iso) and an Export domain, called exp,
(NFS Export Path: admin.cluster:/nfs/export).
In each node with gluster, the /data directory is used to create the
volume vol1 (type: Replicate)
The Data domain is called vms (NFS Export Path: localhost:/vol1).
Some help wil be appreciated
Fernando M.