Re: [ovirt-users] workflow node installation

On 05/26/2014 04:15 AM, Fabian Deutsch wrote: > Am Sonntag, den 25.05.2014, 09:01 -0400 schrieb Doron Fediuck: >> Don't we have ovirtmgmt defined by default >> during the registration process? > > Hey, > > IIRC that is done by ovirt-host-deploy during the registration, yes. > > - fabian > >> ----- Forwarded Message ----- >>> From: "Jorick Astrego" <j.astrego(a)netbulae.eu&gt; >>> To: "users" <users(a)ovirt.org&gt; >>> Sent: Monday, May 19, 2014 1:11:58 PM >>> Subject: [ovirt-users] workflow node installation >>> >>> Hi, >>> >>> I don't know if I'm doing things wrong but the workflow for node >>> installation >>> is a bit cumbersome for me. >>> >>> The things I have to do to get a node up in ovirt engine: >>> >>> - install node image from pxe >>> - approve node >>> - put node into maintenance mode (storage not available) >>> - Setup Host Networks >>> - Sync network (otherwise I cannot save the network changes) >>> - Setup Host Networks again >>> - Save Network setup >>> - activate node >>> This seems problematic to me -- the host networks should be automatically set when you approve the node joining a given cluster. Are you setting up the host networks on the engine side, or do you have to approve, log back into the node, configure networking, etc?

>>> And this I have to do for every node. It could save me some time if >>> I could >>> setup the networks on approval or engine puts it directly into >>> maintenance >>> mode without the sync requirement. >>> >>> Kind regards, >>> >>> Jorick Astrego >>> Netbulae B.V. >>> >>> _______________________________________________ >>> Users mailing list >>> Users(a)ovirt.org >>> http://lists.ovirt.org/mailman/listinfo/users >>> > >