Re: [ovirt-users] Team a NIC and add to ovirtmgmt vNIC

Hi, If I understood correctly, this operation does not incur a long downtime. ​To setup the bond, first ​y ou'll need to select the relevant host, select *​​Network Interfaces* and click *​​Setup Host Networks*. At this step, you should be presented with *​​NIC0* (eth0?) connected to *​​ovirtmgmt*, and a standalone (and possibly down) *​​NIC1* (eth1 ​?​ ). Just drag and drop *​​NIC1* unto *​​NIC0*, choose bond type and press *​​OK*. After the bond is displayed, make sure you've selected both " *​​Verify connectivity between Host and Engine*" and " *​​Save network configuration*" options, and ​again ​ press *​​OK* ​.​ ​If all goes well, after the configuration you'll have a working bond with ovirtmgmt on top of it. You'll have to repeat this for all hosts you'll be configuring the new bond... All network downtime will be the total time of bringing down eth0, creating bond0 and bringing up bond0 - no more than a fraction of a minute normally. And this will only effect the guests on that particular Host, not the whole cluster.​ A little side note on migrating from a single nic to a bond: if you plan to add more VLAN tagged virtual networks to your new bond, keep in mind that ovirtmgmt should also be VLAN tagged - you can not mix tagged and untagged networks on a single bond. ​Regards, On Mon, May 18, 2015 at 5:58 PM, Christophe TREFOIS < christophe.trefois(a)uni.lu&gt; wrote: -- *Ekin Meroğlu** Red Hat Certified Architect* linuxera Özgür Yazılım Çözüm ve Hizmetleri *T* +90 (850) 22 LINUX | *GSM* +90 (532) 137 77 04 www.linuxera.com | bilgi(a)linuxera.com