Hi Bill, Yes, the document is already dated. Lately, you don't have to go through the hoops needed to make spice-x work. Even if you can get it, it will only work for you in IE < 11. You should instead just install virt-viewer [1] and the consoles should Just Work for you using the Natice Client (.vv file) method. David [1] http://virt-manager.org/download/ On Fri, 2014-09-19 at 07:20 +0000, Bill Dossett wrote:
Hi
After setting up an ovirt cluster with 4 hosts and getting my networking and vlans all connected I’m pretty impressed with ovirt. I am however not too impressed with trying to actually get a console into a VM. I’m not sure why this isn’t included in the ovirt engine to begin with as console access to actually configure a VM to make templates of seems a pretty basic tenant of virtualisation.
Anyway, I am following the guide http://www.ovirt.org/How_to_Connect_to_SPICE_Console_With_Portal and trying to download spice.cab to follow the rather long procedure to install, however the link on that page gives a 404 page not found error. Could someone point me to the actual download? Is this document perhaps outdated and I am following the wrong path?
Thanks
Bill Dossett
Virtualisation Architect
Pitney Bowes – Tech Central
6 Hercules Way, 600 Leavesden Park
Watford, WD25 7GS
Phone(+44) (0)1923 279353 | VOIP: 54739353
Mobile(+44) (0)7775 908612
bill.dossett@pb.com
www.pb.com
In Engineering?Raise a ticket via Remedy Anywhere [HERE]takes less than a minute
ManageIQ User Guide available [HERE]
Check out the ManageIQ Blog for recent enhancements and information [HERE]
______________________________________________________________________
_______________________________________________ Users mailing list Users@ovirt.org http://lists.ovirt.org/mailman/listinfo/users