Hi,
You can manually do the resize (Steps here are for FC) :
- Move the Storage Domain to maintenance
- First locate the LUN ID you want to refresh with :multipath -ll
On each hosts:
- Run : rescan-scsi-bus.sh
- Run: multipathd resize map 3600a0b800075de8f00000e3a52ddf25f (replace
with your LUN_ID)
- Check that the size was updated in multipat -ll
On the SPM:
- Run: pvresize /dev/mapper/3600a0b800075de8f00000e3a52ddf25f
- Check with vgs
Move the domain to active again.
I am not sure that the engine will see the new size immediately. An engine
restart might be needed.
Regards,
Fred
On Wed, Jun 28, 2017 at 9:18 AM, Enrico Becchetti Gmail <
enrico.becchetti(a)gmail.com> wrote:
Hi All,
There are other ways to avoid using two lun ? If necessary I can also
shutdown the entire cluster.
thanks a lot !
Bye
Enrico
Il 26/06/2017 12:32, Fred Rolland ha scritto:
Hi,
The support for refreshing the LUN size in an existing storage domain has
been introduced in 3.6, so it is not relevant for you.
You can add an additional LUN to an existing storage domain.
Regards,
Fred
[1]
https://www.ovirt.org/develop/release-management/features/
storage/lun-resize/
On Mon, Jun 26, 2017 at 9:35 AM, Enrico Becchetti Gmail <
enrico.becchetti(a)gmail.com> wrote:
> Dear All,
> I've oVirt 3.5.3-1-1.el6 with two kind of storage , NFS and Fibre
> Channel. Each Hypervisor
> has HBA controller and Data CLutser has four Storage named: DATA_FC,
> DATA_NFS, EXPORT
> and ISO-DOMAIN.
>
> Anybody know how can I extend a DATA_FC ? Which is the best practies ?
> Extend LUN from HP MSA controller or adding a new lun ?
> if I extend lun inside HP MSA oVirt see the new size ?
> Enrico
> Thanks a lot.
> Best Regards
>
> _______________________________________________
> Users mailing list
> Users(a)ovirt.org
>
http://lists.ovirt.org/mailman/listinfo/users
>