Re: [Users] Network profile lost after host edit
Hi Simon,
I apologize for the delay in my response. I've worked quite a bit on
that part of the dialog since oVirt 3.3, and while it was quite buggy I
haven't encountered this exact issue you're describing. It does remind
me of one bug though; could it be that pressing the "Show Advanced
Options" is what triggers the strange behavior?
What version of oVirt engine are you running? Both 3.3.1 and 3.3.2
should be quite stable as far as this dialog is concerned, so upgrading
might be a good idea.
As for workarounds, it sounds like a GUI issue so I don't think there's
anything you can do apart from upgrading the engine.
Yours, Lior.
On 11/12/13 13:40, Simon Barrett wrote:
I have a problem where VM network profiles are lost when editing a
host.
E.G.
· VM is running fine on the correct network. Network Interfaces
tab shows nic1 and Network Name shows the correct network profile.
· I shutdown the VM then right click and Edit.
· The General settings for the node shows nic1 <Empty>. If I
then edit config, something like increasing memory or changing CPU cores
then click on OK, the VM configuration is saved without a network profile.
· When I boot the VM I cannot connect to it.
· I then have to edit the node again configure back in the
correct network profile.
Does anyone know if this is a known issue? If not, any suggestions as to
how I correct this so that the original network profile definition is
retained after an edit?
Many thanks,
Simon
_______________________________________________
Users mailing list
Users(a)ovirt.org
http://lists.ovirt.org/mailman/listinfo/users