Re: [Users] Exception: ValueError("invalid literal for int() with base 10: ' '", )

From: "Jorick Astrego" <j.astrego(a)netbulae.eu&gt; To: "Fabian Deutsch" <fabiand(a)redhat.com&gt; Cc: users(a)ovirt.org Date: 19/09/2013 12:53 Subject: Re: [Users] Exception: ValueError("invalid literal for int() with base 10: ' '", ) Hi, I'm using ovirt-node-iso-3.0.1-1.0.2.vdsm.fc19.iso and I tried reproducing on two nodes. I thought maybe the first node's SSD had failed. See screenshots attached (they are very small). As the Local disk first only reported 1GB, i used Other device /dev/sda and got the ValueError (xxx_144.png). When using Local disk, I get a 'Read-only file system' error. (xxx_145.png) This is on two identical nodes with a SSD connected through LSI MegaRAID. I could try it without RAID, but I'll have to visit the datacenter and reflash the LSI firmware for this. Both nodes had an older 2.6 node image running on it before. After a full RAID re-initialization that produced no errors, I now get yet another faillure: "Exception: RuntimeError('Failed to set install bootloader'.)" (xxx_147.png) Can it be the SSD or RAID controller? I could swap out the SSD for a 2.5 hdd to test it out. Thanks in advance! Jorick Astrego Netbulae B.V. -----Original Message----- > From: "Fabian Deutsch" <fabiand(a)redhat.com&gt; > To: "Jorick Astrego" <j.astrego(a)netbulae.eu&gt; > Cc: users(a)ovirt.org > Date: 18/09/2013 15:49 > Subject: Re: [Users] Exception: ValueError("invalid literal for int() with base 10: ' '", ) > > Hey, > > Am Mittwoch, den 18.09.2013, 15:35 +0200 schrieb Jorick Astrego: > > I'm trying to deploy the ovirt node 3.0.1-1.0.2 image. Because we only have a small SSD and don't need overcommit I changed the swap file size to a smaller value. > > > > While installing I now get the following error and have to reboot: > > > > Exception: ValueError("invalid literal for int() with base 10: ' '",) > > I tried to reproduce this problem but couldn't trigger it using: > 1. Enter the storage sizes page > 2. Changed the swap value to 100 (allowed value depends on your hosts >    mem size) > 3. Saved page, went through the next pages and installed > > Could you explain in detail how you triggered this problem? > And are you using the fc19 or el6 iso? > > Greetings > fabian > > > > If I don't change the value of the swap, I get a message that the installer is unable to format/partition the disk. > > > > Kind regards, > > > > Jorick Astrego > > > > > > > > > > _______________________________________________ > > Users mailing list > > Users(a)ovirt.org > > http://lists.ovirt.org/mailman/listinfo/users

Users mailing list Users(a)ovirt.org http://lists.ovirt.org/mailman/listinfo/users