
----- Original Message -----
From: "Federico Alberto Sayd" <fsayd@uncu.edu.ar> To: users@ovirt.org Sent: Tuesday, January 28, 2014 5:23:13 PM Subject: Re: [Users] ***UNCHECKED*** Re: [vdsm] ovirtmgmt vanishes after reboot
On 28/01/14 11:27, Francisco Pérez wrote:
Im setting up two networks. ovirtmgmt and a LAN. Both of them are gone after reboot on the node, its starts only with eth0 initial configuration.
Antoni, here are the outputs you requested:
[root@ovirth1 ~]# /etc/init.d/vdsmd status VDS daemon server is running [root@ovirth1 ~]# service vdsmd status VDS daemon server is running [root@ovirth1 ~]# virsh -r net-list setlocale: No such file or directory Name State Autostart Persistent -------------------------------------------------- ;vdsmdummy; active no no
[root@ovirth1 ~]# ls /etc/sysconfig/network-scripts/ ifcfg-eth0 ifdown-eth ifdown-post ifdown-tunnel ifup-eth ifup-plip ifup-routes init.ipv6-global route-LAN ifcfg-lo ifdown-ippp ifdown-ppp ifup ifup-ippp ifup-plusb ifup-sit net.hotplug route-ovirtmgmt ifdown ifdown-ipv6 ifdown-routes ifup-aliases ifup-ipv6 ifup-post ifup-tunnel network-functions rule-LAN ifdown-bnep ifdown-isdn ifdown-sit ifup-bnep ifup-isdn ifup-ppp ifup-wireless network-functions-ipv6 rule-ovirtmgmt
Just to maek sure, /etc/vdsm/vdsm.conf does not modify net_persistence nor net_configurator, does it? If it does not, and you ticked "Save" on the setupNetworks dialogs, there is some issue with the net persistence flow on the ovirt node and a bug should be opened for it.
Dan those command are excecuted where? on the manager or the node? Im new at this and the logs are a little overwhelming so if you help me to interpret them i'll apreciate them. I have attached the whole log directory /var/log/vdsm/
Regards
On Thu, Jan 23, 2014 at 4:32 PM, Dan Kenigsberg < danken@redhat.com > wrote:
On Thu, Jan 23, 2014 at 05:12:17PM +0100, Fabian Deutsch wrote:
Am Donnerstag, den 23.01.2014, 12:34 -0300 schrieb Francisco Pérez:
Hi. I have configured an ovirt-engine to manage an ovirt node succesfully. I have created VM and all runs well but im trying to do some escenario testing and i have found an issue.
If somehow the ovirt node is rebooted(Power failure, crash, manual reboot, etc) when its comes up it does not start the ovirtmgmt network. Even if in the ovirt-engine you save network configuration or if you execute persist on /etc/sysconfig/network-scripts/ifcfg-ovirtmgmt. It tells you it's already been added to the configuration.
Is this normal behavior after ovirt node's is rebooted? Am i doing something wrong?
Hey Francisco,
that sounds like a bug. VDSM Devs, how can we debug why the network is not brought up?
Could you share vdsm.log and supervdsm.log? When you set up ovirtmgmt, as setupNetworks command should be visible there. Later, on "save", a call to setSafeNetworkConfig is sent, which is expected to persist your network configuration.
Is it visible? Is it successful?
What do you see in the logs post boot? Can you tell whether the vdsm-restore-net-config.init server was run? (its job is to revert unsaved network config changes on non-ovirt-nodes).
_______________________________________________ Users mailing list Users@ovirt.org http://lists.ovirt.org/mailman/listinfo/users I had the same issue with 3.0.1-1.0.2.el6, I saw other posts about this problem ( http://lists.ovirt.org/pipermail/users/2013-September/016705.html ) and then I decided to discard ovirt-node and use a full blown distro (Centos 6.5)
Regards
Federico
_______________________________________________ Users mailing list Users@ovirt.org http://lists.ovirt.org/mailman/listinfo/users