On 07/09/2012 10:59 PM, Justin Clift wrote:
On 10/07/2012, at 5:53 AM, Itamar Heim wrote: <snip>
Installation was performed from F17 using the "from rpm" instructions here:
http://www.ovirt.org/wiki/Installing_VDSM_from_rpm
_Guessing_ the "ssl = false" bit is causing the problem. No idea how to either enable ssl in the host, or turn it off in Engine though. (or anything else that works :>)
why would you have ssl = false anywhere?
That's what the above steps in the "Installing VDSM from rpm" instructions say to do. My understanding of the pieces in oVirt isn't yet great enough to do stuff _without_ following instructions yet. ;)
are you installing them both on same host? "this (these) steps are usually not required when installing VDSM on another host than ovirt-engine" if you do want on same host, this is old and should probably be superseded by: http://www.ovirt.org/wiki/Feature/AllInOne (not sure has a wiki on how to use, but basically you just need to install the allinon setup plugin rpm adn run installer