Hi Dan I should have mentioned that we need to use the same subnet for both iSCSI interfaces which is why I ended up bonding (mode 1) these. Looking at https://access.redhat.com/documentation/en-US/Red_Hat_Enterprise_Virtualizat..., it doesn't say anything about tying the iSCSI Bond back to the host. In our DEV environment I removed the bond the iSCSI interfaces were using and created the iSCSI Bond as per this link. What do I do now? Recreate the bond and give it an IP? I don't see where to put an IP for iSCSI against the hosts? Lastly, not using jumbo frames as where a critical infrastructure organisation and I fear possible side effects. Thanks On Sat, Jun 25, 2016 at 10:30 AM, Dan Yasny <dyasny@gmail.com> wrote:
Two things off the top of my head after skimming the given details: 1. iSCSI will work better without the bond. It already uses multipath, so all you need is to separate the portal IPs/subnets and provide separate IPs/subnets to the iSCSI dedicated NICs, as is the recommended way here: https://access.redhat.com/solutions/131153 and also be sure to follow this: https://access.redhat.com/documentation/en-US/Red_Hat_Enterprise_Virtualizat... 2. You haven't mentioned anything about jumbo frames, are you using those? If not, it is a very good idea to start.
And 3: since this is RHEV, you might get much more help from the official support than from this list.
Hope this helps Dan
On Fri, Jun 24, 2016 at 9:12 PM, Colin Coe <colin.coe@gmail.com> wrote:
Hi all
We run four RHEV datacenters, two PROD, one DEV and one TEST/Training. They are all working OK but I'd like a definitive answer on how I should be configuring the networking side as I'm pretty sure we're getting sub-optimal networking performance.
All datacenters are housed in HP C7000 Blade enclosures. The PROD datacenters use HP 4730 iSCSI SAN clusters, each datacenter has a cluster of two 4730s. These are configured RAID5 internally with NRAID1. The DEV and TEST datacenters are using P4500 iSCSI SANs and each datacenter has a cluster of three P4500s configured with RAID10 internally and NRAID5.
The HP C7000 each have two Flex10/10D interconnect modules configured in a redundant ring so that we can upgrade the interconnects without dropping network connectivity to the infrastructure. We use fat RHEL-H 7.2 hypervisors (HP BL460) and these are all configured with six network interfaces: - eno1 and eno2 are bond0 which is the rhevm interface - eno3 and eno4 are bond1 and all the VM VLANs are trunked over this bond using 802.1q - eno5 and eno6 are bond2 and dedicated to iSCSI traffic
Is this the "correct" way to do this? If not, what should I be doing instead?
Thanks
CC
_______________________________________________ Users mailing list Users@ovirt.org http://lists.ovirt.org/mailman/listinfo/users