[ovirt-users] Re: private networking question

Hello Matthew, oVirt by default lists only dummy interfaces in format dummy_*. You can change this configuration on your node in /etc/vdsm/vdsm.conf via 'fake_nics'. Hope that helps, Petr 2018-06-03 20:44 GMT+02:00 Matthew Wimpelberg <archsupport(a)protonmail.com&gt;: > Hi, > I'm currently running oVirt with a self hosted engine configuration on an Intel NUC. All of my VMs are on my home 192.168.1.0/24 network, but I want to set up a completely isolated network like VirtualBox has (https://blogs.oracle.com/scoter/virtualbox-host-only). The NUC that I have only has one NIC so I think I'll have to set up a dummy interface of some kind. I tried that with the below example. I couldn't find a good guide or doc on this. Can someone please assist? > > [root@host ~]# cat /etc/sysconfig/network-scripts/ifcfg-dummy0 > DEVICE=dummy0 > BOOTPROTO=none > ONBOOT=yes > NM_CONTROLLED=no > PROMISC=yes > > 3: dummy0: <BROADCAST,NOARP,UP,LOWER_UP> mtu 1500 qdisc noqueue master vnet0 state UNKNOWN group default qlen 1000 > link/ether 52:54:00:7e:27:af brd ff:ff:ff:ff:ff:ff > inet6 fe80::5054:ff:fe7e:27af/64 scope link > valid_lft forever preferred_lft forever > > Sent with [ProtonMail](https://protonmail.com) Secure Email. > > _______________________________________________ > Users mailing list -- users(a)ovirt.org > To unsubscribe send an email to users-leave(a)ovirt.org > Privacy Statement: https://www.ovirt.org/site/privacy-policy/ > oVirt Code of Conduct: https://www.ovirt.org/community/about/community-guidelines/ > List Archives: https://lists.ovirt.org/archives/list/users@ovirt.org/message/AK2DQ3EMTP7...