Hello, I am hoping someone here has had experience in setting up an iSCSI target using 'targetcli'. I followed the following guide: <http://www.certdepot.net/rhel7-configure-iscsi-target-initiator-persistently/>. This is on my single host (with hosted engine currently running; I am using a seperate HDD for the iSCSI storage) The iSCSI initiator of my host, from it's information page in oVirt, is <iqn.1994-05.com.redhat:ba4cc8b3368e>, so I created an ACL with that name. Here is a result of the listing in the 'acls' directory for my IQN: --- START --- /iscsi/iqn.20...gt1/tpg1/acls> ls o- acls .............................................................. [ACLs: 1] o- iqn.1994-05.com.redhat:ba4cc8b3368e ...................... [Mapped LUNs: 1] | o- mapped_lun0 .................................... [lun0 block/block1 (rw)] --- END --- So it appears as though my host's initiator is mapped to my LUN 0. When I go in to oVirt and add iSCSI storage, the "Discover" finds my target, and I can even log in successfully, however when I click on the "LUNS->Targets" side tab, there are no LUNs listed, so I cannot add any iSCSI storage. Any ideas on why the LUN is not showing up? Thanks! :-) Regards, Alan