
2012/10/8 Fabian Deutsch <fabiand@redhat.com>
Am Montag, den 08.10.2012, 09:24 +0100 schrieb Alexandre Santos:
2012/10/8 Fabian Deutsch <fabiand@redhat.com> Hey,
Am Sonntag, den 07.10.2012, 15:29 +0100 schrieb Alexandre Santos: > Hi, > I'm trying to install the ovirt-node iso image on a SATA disk and when > it gets to the screen where it shows 25% completed the kernel hangs. I > can't connect using a serial console to see what has happened. If I > reboot using a usb linux disk I see that the SATA disk has been > formated and the partitions that existed before disappeared, being > there just one partition of type "ee"
Is there any error displayed when kernel hangs at 25%? And it can take some time to pass the 25% (up to ~2min or so).
No, I think it's a kernel hang because the lights on the keyboard halt and I can't change to tty2, etc.. I even changed to tty2 and waited to see if there were some errors but nothing. I've read that "tty8" was the logging console but no luck also. BTW, I tried with an IDE disk and the result was the same.
Mh, okay. Could you try booting without the rhgb and quiet kernel arguments. I hope that some errors will be displayed on the screen so we get an idea about the problem.
> If I use a 8 GB usb pen-drive instead of the SATA disk, the > installation comes to an end and I reboot but then I get some error > about not getting /dev/mapper/by-name/Root and the boot fails to a > dracut shell. > Any ideas?
In the dracut shell, could you run blkid and post the results?
I noticed that the USB Disk was named RootBackup instead of Root... I then rebooted and chose uninstall and then installed oVirt Node from scratch and now it worked. I can't activate Networking because I have that "no hostname" error mentioned in another post. I think it's related to that...
Yes, I've also seen the hostname error. And I've also seen some problems with the rootfs lately. Could you provide a screenshot/dump of the console with that error?
- fabian
Ok! I'll send them as soon as possible. Alex