Seems strange. I want to use q35, but whenever I try even to start the installation (vm disk using virtio-scsi/virtio, net adapter using virtio) it always shows me the installer doesn’t detect any disk. I have an existing VM too that recently upgraded from 12.2 to 13. It uses i440FX with virtio-scsi disk and virtio network. If I try to change the machine into q35, it keeps stuck at boot after “promiscuous mode enabled”. Don’t know what’s wrong. Using oVirt 4.4.5. Can you share your VM Config ? From: Thomas Hoberg<mailto:thomas@hoberg.net> Sent: 20 April 2021 17:27 To: users@ovirt.org<mailto:users@ovirt.org> Subject: [ovirt-users] Re: FreeBSD 13 and virtio q35 with BIOS as that is the cluster default with >4.3. Running the dmesg messages through my mind as I remember them, the vio hardware may be all PCIe based, which would explain why this won't work on a virtual FX 440FX system, because those didn't have PCIe support AFAIK. Any special reason why you'd want them based on 440FX? And I also tested with GhostBSD, which is still 12.* based, and that doesn't seem to have vio support, at least I could not see a hard disk there, which confirms your observation there. _______________________________________________ Users mailing list -- users@ovirt.org To unsubscribe send an email to users-leave@ovirt.org Privacy Statement: https://apac01.safelinks.protection.outlook.com/?url=https%3A%2F%2Fwww.ovirt... oVirt Code of Conduct: https://apac01.safelinks.protection.outlook.com/?url=https%3A%2F%2Fwww.ovirt... List Archives: https://apac01.safelinks.protection.outlook.com/?url=https%3A%2F%2Flists.ovi...