On Tue, Feb 12, 2013 at 10:27 PM, Moti Asayag wrote:
You should follow the next steps:
1. Create a new logical network from the networks main tab: define its data-center and set its vlan-id to 50 (the VM network checkbox should be checked) 2. Click on the created network in the networks main tab ---> Select the 'Clusters' sub-tab and ---> click on 'Assign/Unassign Network' and attach the network to the cluster (which contains the hosts that are expected to run the VMs). 3. Click on 'hosts' sub-tab of the network main tab for the same network. You should be able to see the cluster's hosts. Select a host and click on 'Setup Networks'. 4. In the 'setup networks' dialog you would see the host's interfaces on the left side and the logical networks definition on the right. Drag the network on top of an interface, or first drag a nic on top of another to create a bond and then drag the network to that bond. A command will be sent from the engine to the vdsm on the host to configure the desired network configuration. 5. In order to persist the network configuration on the host you can check the 'save network configuration' from 4.
Hello, I followed these steps to create a bonded VM network (no vlan tagging) with 3.2 beta. Only differences - assignement of network to cluster (step 2) can also be completed while in step 1) - step 3 : to see the host and setup networks for it you have to select the "unattached" check box I don't understand if and how I can put lan parameters if I don't use vlan tagging I don't see any option for that, when I edit the "network" itself or go through the "setup host networks" For example the VMs that will attach to this new network that I called "client" will have ip of the form 10.10.10.x/24 with gw 10.10.10.1 and eventually I would like to give an ip address to the created bond itself. Can I? Thanks, Gianluca