Re: [ovirt-users] change network MTU settings without taking all the VMs down?

Hi Darrell! There's currently no clean way to do this - we'll be looking to fix this in 3.6 (https://bugzilla.redhat.com/show_bug.cgi?id=1055454). You haven't mentioned which version of oVirt you're running - if it's 3.4 or lower, I think it would suffice to change ifcfg files on your hypervisors and restart the network service. The network will then appear as out-of-sync in the GUI, but should be fully functional with MTU 1500. You'd also want the network configuration to be saved in case of future rollbacks - Dan, how would that be done? If you're running 3.5, I think you need to run some vdsm shell commands on the hypervisor as we've added an abstraction layer for configuration persistence above ifcfg files - again I'll ask Dan to chime in. As for getting the engine network configuration to MTU 1500 (for future hypervisor configuration and for networks to not appear as out-of-sync on existing ones) without taking down all the VMs (or hot-unplugging NICs) at one point - I don't think there's currently a way other than hacking the DB... Just leaving the network out-of-sync on the hosts could result in inconveniences later on when configuring host networking. Is it worth the trouble of getting MTU 1500 instead of 1448? I presume the difference in performance would be negligible. Or are you experiencing incoming frames being dropped due to having 1500 bytes instead of 1448?... Either way, as you mentioned taking down the VMs can be a last resort, or wait for 3.6 where it should be simpler :) Yours, Lior. On 27/01/15 19:43, Darrell Budic wrote: