Re: [ovirt-users] Configuration of FCoE in oVirt 4.2 on HP BladeSystem c7000

Thanks, Fred. I have been looking at FCoE VDSM Hooks to no help. Looking at it again, I am still not able to see any FCoE [root@ovirtengine ~]# engine-config -g UserDefinedNetworkCustomProperties UserDefinedNetworkCustomProperties: version: 3.6 UserDefinedNetworkCustomProperties: version: 4.0 UserDefinedNetworkCustomProperties: fcoe=^((enable|dcb|auto_vlan)=(yes|no),?)*$ version: 4.1 UserDefinedNetworkCustomProperties: fcoe=^((enable|dcb|auto_vlan)=(yes|no),?)*$ version: 4.2 I finally managed to find the "custom Property" where I could set "enable=yes,dcb=no" for fcoe, but when applying the change, I get unexepected error. Yes, the host was in local maintenance mode when I applied the change. I am afraid I am not understanding all the steps needed from the Virtual Connect configuration in the blade rack to the network interfaces inside oVirt. Should I add a new FCoE only network interface and should this have VLAN/IP address in a special range compared to the internal network in the rack?