On 22/01/14 21:31, Dan Kenigsberg wrote:
On Wed, Jan 22, 2014 at 01:57:35PM -0300, Federico Alberto Sayd wrote:
On 22/01/14 12:13, Dan Kenigsberg wrote:
On Wed, Jan 22, 2014 at 07:43:52AM +0000, Karli Sjöberg wrote:
On Tue, 2014-01-21 at 21:22 -0300, Federico Sayd wrote:
Hello:
I am having problems with bonding
I have installed Centos 6.5 in order to use it as host. I configured eth0 with the vlan of the management network (Vlan 70). Then I registered the host to the engine (3.3.2-1-el6) and the engine installed oVirt in the host without problem. Ovirtmgmt was created automatically and bridged with eth0.70.
Now I need to bond a second network interface (eth1) with eth0. But when I try to bond the nics, I get the next error:
"A slave interface is not properly configured. Please verify slaves do not contain any of the following properties: network name, boot protocol, IP address, netmask, gateway or vlan-ID notation (as part of interface's name or explicitly)" Federico, where exactly do you get this error? Would you attach the setupNetwork log from supervdsmd.log? I get the error in the setup-network dialog in ovirt-engine.
Today I solved the issue copying the network config of other host (same hardware), and it worked.
The supervdsm.log whith the lines logged yesterday:
It would be nice if the error could be more explicit, i.e. telling the ifcfg-* that are conflictive. I do not understand the error yet... I believe that in the text you have quoted, Engine complains that an interface has not joined a bond. But Engine's command to Vdsm
MainProcess|Thread-15::DEBUG::2014-01-21 13:13:21,166::supervdsmServer::95::SuperVdsm.ServerCallback::(wrapper) call setupNetworks with ({'ovirtmgmt': {'nic': 'eth0', 'vlan': '70', 'ipaddr': '192.168.1.101', 'netmask': '255.255.255.0', 'STP': 'no', 'bridged': 'true'}}, {}, {'connectivityCheck': 'true', 'connectivityTimeout': 120}
contains no reference to a bond device, and seems to have succeeded.
One notable problem is that the network definitions lack a 'gateway' parameter, which is very important for ovirtmgmt.
Would you share your vdsm.log, too? The output of getCapabilities before and after setupNetworks may shed some light on the circumstances.
Regads, Dan.
Exactly , Engine doesn't want to create the bond because the configuration of a nic have "unacceptable" parameters. But, specifically what parameters? Which interface? Could the error be more explicit? Engine complains about the contents of ifcfg-* or actual network config? or both? In any case I restarted network service after edit ifcfg-* files. I got the error when I tried to bond the interfaces. The ovirtmgmt was created by oVirt and bridged to eth0.70 when the host was installed via oVirt Engine. After, I tried to bond the two interfaces: eth0, (with ovirtmgmt attached to it) and eth1 (without config), then the gui showed the error about ifcfg-* parameters. I guess that the text that you quoted corresponds to the creation of ovirmgmnt network at install time. I don't find in supervdsm.log any references to the bond creation. vdsm.log: http://pastebin.com/AGSMBnkN Thanks