On 05/26/2014 04:15 AM, Fabian Deutsch wrote:
Am Sonntag, den 25.05.2014, 09:01 -0400 schrieb Doron Fediuck:
Don't we have ovirtmgmt defined by default during the registration process?
Hey,
IIRC that is done by ovirt-host-deploy during the registration, yes.
- fabian
----- Forwarded Message -----
From: "Jorick Astrego" <j.astrego@netbulae.eu> To: "users" <users@ovirt.org> Sent: Monday, May 19, 2014 1:11:58 PM Subject: [ovirt-users] workflow node installation
Hi,
I don't know if I'm doing things wrong but the workflow for node installation is a bit cumbersome for me.
The things I have to do to get a node up in ovirt engine:
- install node image from pxe - approve node - put node into maintenance mode (storage not available) - Setup Host Networks - Sync network (otherwise I cannot save the network changes) - Setup Host Networks again - Save Network setup - activate node
This seems problematic to me -- the host networks should be automatically set when you approve the node joining a given cluster.
Are you setting up the host networks on the engine side, or do you have to approve, log back into the node, configure networking, etc?
And this I have to do for every node. It could save me some time if I could setup the networks on approval or engine puts it directly into maintenance mode without the sync requirement.
Kind regards,
Jorick Astrego Netbulae B.V.
_______________________________________________ Users mailing list Users@ovirt.org http://lists.ovirt.org/mailman/listinfo/users