Re: [ovirt-users] Q: Partitioning - oVirt 4.1 & GlusterFS 2-node System

Hi, Donny, Thanks for the link. Am I understood correctly that I'm need at least 3-node system to run in failover mode? So far I'm plan to deploy only 2 nodes, either with hosted either with bare metal engine. *The key thing to keep in mind regarding host maintenance and downtime is that this converged three node system relies on having at least two of the nodes up at all times. If you bring down two machines at once, you'll run afoul of the Gluster quorum rules that guard us from split-brain states in our storage, the volumes served by your remaining host will go read-only, and the VMs stored on those volumes will pause and require a shutdown and restart in order to run again.* What happens if in 2-node glusterfs system (with hosted engine) one node goes down? Bare metal engine can manage this situation, but I'm not sure about hosted engine. On 12/13/2017 11:17 PM, Donny Davis wrote: I would start here https://ovirt.org/blog/2017/04/up-and-running-with-ovirt- 4.1-and-gluster-storage/ Pretty good basic guidance. Also with software defined storage its recommended their are at least two "storage" nodes and one arbiter node to maintain quorum. On Wed, Dec 13, 2017 at 3:45 PM, Andrei V <andreil1(a)starlett.lv&gt; wrote: > Hi, > > I'm going to setup relatively simple 2-node system with oVirt 4.1, > GlusterFS, and several VMs running. > Each node going to be installed on dual Xeon system with single RAID 5. > > oVirt node installer uses relatively simple default partitioning scheme. > Should I leave it as is, or there are better options? > I never used GlusterFS before, so any expert opinion is very welcome. > > Thanks in advance. > Andrei > _______________________________________________ > Users mailing list > Users(a)ovirt.org > http://lists.ovirt.org/mailman/listinfo/users > _______________________________________________ Users mailing list Users(a)ovirt.org http://lists.ovirt.org/mailman/listinfo/users