
I wonder about that dirty yum upgrade bit -- I upgraded a remote F15 server to F16 yesterday using preupgrade-cli and then went on to configure that server as engine+host as you're doing. It worked fine. On 03/01/2012 10:41 AM, Michal Kopacki wrote:
-------------------------------------------------------------- On 2012-03-01 17:42:42 , Itamar Heim (iheim@redhat.com) wrote:
not sure about the error below, but installing vdsm requires more configuration done by engine when you choose to add a host.
can you try adding the host via the engine (it will reboot in the last phase...). It's exactly what I did. After vsdm install I went to ovirt-engine
I'm not sure what you mean by "more configuration". As I understand after install of vdsm it will be started as a service which apparently is not going well. page and add host (localhost in this case). In event window i saw that there are components installing and after reboot i can see information as below:
"This host is in non responding state. Try to Activate it; If the problem persists, switch Host to Maintenance mode and try to reinstall it."
Of course Activate solves nothing.