[ovirt-users] Re: Hosted Engine Setup error (oVirt v4.2.3)

https://www.ovirt.org/documentation/install-guide/chap- System_Requirements/ says: Important: If you are also installing the oVirt Engine Virtual Appliance for self-hosted engine installation, the /var partition must be at least 60 GB.

Back to the drawing board, I certainly failed to read that!! On 2018-05-16 02:37, Andrea Dell'Amico wrote: > On 16 May 2018, at 09:42, Simone Tiraboschi <stirabos(a)redhat.com&gt; >> wrote: >> >> On Tue, May 15, 2018 at 6:31 PM, <ovirt(a)fateknollogee.com&gt; wrote: >> >> Engine network config error >>> >>> Following this blog post: >>> >>> >> https://www.ovirt.org/blog/2018/02/up-and-running-with-ovirt > -4-2-and-gluster-storage/ > >> [1] >>> >>> I get an error saying the hosted engine setup is "trying" to use >>> vibr0 (192.168.xxx.x) even though I have the bridge interface set >>> to "eno1" >>> >> >> Regardless of whether the Edit Hosts File is checked or unchecked, >>> it overwrites my engine IP entry from 10.50.235.x to 192.168.xxx.x >>> >>> The same thing happens whether I set the engine IP to Static or >>> DHCP (I don't have DNS, I'm using static entries in /etc/hosts). >>> >>> Any ideas it "insists" on using "vibr0" instead of "eno1"? >>> >> >> Hi, >> up to this point is absolutely fine: in the new node zero deployment >> flow, hosted-engine-setup bootstraps a local VM with an engine there >> to use that engine to configure the rest of the system (storage, >> network...). >> That bootstrap VM runs over default natted libvirt network, that's >> why you see vibr0 and 192.168.xxx.x at that stage. >> >> If you are facing any issue, it's definitively not there. >> > > Yes, the blog post describes the 4.2.{0,1} behaviour while the local > VM is a change introduced in 4.2.2. > I faced a similar error and in my case the VM creation failed because > there was not enough space in /var/tmp. It wasn’t a problem before, > because the engine VM was created directly on top of a gluster volume. > > Andrea > -- > Andrea Dell'Amico > http://adellam. sevenseas.org/ [2] > > > > Links: > ------ > [1] > https://www.ovirt.org/blog/2018/02/up-and-running-with-ovirt > -4-2-and-gluster-storage/ > [2] http://sevenseas.org/ > _______________________________________________ > Users mailing list -- users(a)ovirt.org > To unsubscribe send an email to users-leave(a)ovirt.org >