Re: [Users] NIC problem with ovirt node
On 12/07/2013 1:27 PM, Mike Burns wrote:
On 07/12/2013 01:22 PM, Jason Keltz wrote:
>>> :) but when I'm in the engine, I can click on the node, and see that
>>> it's up. I can click on network interfaces, and see that one is
>>> up, and
>>> the other are down. I can create networks on the engine, and I can
>>> assign the nodes interfaces to those networks, but for the life of
>>> me, I
>>> can't figure out where I assign an IP to the nodes interfaces!!
>>> Surely,
>>> the place to do that would be under the "Host" tab, yet it
doesn't
>>> seem
>>> to be there...
>>
>> Host Tab -> Network Interfaces -> click on Setup Host Networks
>>
>> On the popup, hover over the logical network (not the nic) and a
>> little pencil or pen (or some other graphic) that is used for
>> editing. Click on that and you'll get another popup where you can
>> choose static/dhcp and set gateway, ip and netmask.
>>
> Thank you *so* much! I did not see the little pencil!!!
Happy to help (and yes it was hard to see...)
Actually, Mike -- two of my networks were private and didn't need a
gateway... but two are public, and need a gateway! Unfortunately, the
interface seems to be missing that option!? It lets you configure an
IP, and a subnet mask, but where's the option for specifying a gateway
if you're specifying static addresses... (my guess is that it picks up
the gateway if you're using DHCP).
Jason.