On 04/13/2012 07:58 PM, Christian Hernandez wrote:
are you sure it is enabled at bios level? did you perform a cold boot post changing it?
I am using CentOS 6.2 on both oVirt server and Host client
And IN FACT you are right; I looked in the BIOS and it was disabled! The node was added successfully now; thank you
can you please check what did the error show in the engine when standing on the host in install failed status (under the subtab of events) - if you didn't remove the host and just re-installed it should still be there, or in the main events tab? thanks, Itamar
--Christian
On Fri, Apr 13, 2012 at 9:52 AM, Itamar Heim <iheim@redhat.com <mailto:iheim@redhat.com>> wrote:
On 04/13/2012 06:32 PM, Christian Hernandez wrote:
Hello,
I am getting an error trying to add a "host" to oVirt where the Status says "Install Failed"
Here is (a snipet ) the log from the oVirt server (/var/log/ovirt/enginge.log)..__.I can provide more if needed
/=============================__======oVirt Server:
...
<BSTRAP component='VT_SVM' status='FAIL' processor='Intel' message='Server does not support virtualization'/>
this is causing the host to fail install.
...
/
I checked on the host itself and it seems like I do have an Intel Hardware Virt on the server (wasn't a surprise since I BOUGHT it that way...but still checked)
are you sure it is enabled at bios level? did you perform a cold boot post changing it?
/=============================__============ Node: /proc/cpuinfo ==============================__===============/
/[root@bluejay ~]# egrep --color 'svm|vmx' /proc/cpuinfo | sort -u
flags : fpu vme de pse tsc msr pae mce cx8 apic mtrr pge mca cmov pat pse36 clflush dts acpi mmx fxsr sse sse2 ss ht tm pbe syscall nx lm constant_tsc arch_perfmon pebs bts rep_good aperfmperf pni dtes64 monitor ds_cpl vmx est tm2 ssse3 cx16 xtpr pdcm dca sse4_1 xsave lahf_lm dts tpr_shadow vnmi flexpriority/
/=============================__==============================__==============================__=============/
Some things to note...
On the Node (under the /etc/vdsm/vdsm.conf file) I have the "fake_kvm_support = true" to see if that would make the node install (didn't work)...also I have "ssl = false" to see if it might be a cert error (still didn't work).
is this an ovirt node or regular fedora?
And, yes, I've even tried removing and adding the node again...still no luck =\
What are my next steps? Any help would be greatly appreciated!
--Christian
_________________________________________________ Users mailing list Users@ovirt.org <mailto:Users@ovirt.org> http://lists.ovirt.org/__mailman/listinfo/users <http://lists.ovirt.org/mailman/listinfo/users>
_______________________________________________ Users mailing list Users@ovirt.org http://lists.ovirt.org/mailman/listinfo/users