Re: [Users] Centos 6.5 and bonding: "A slave interface is not properly configured"

Hello: I am having problems with bonding I have installed Centos 6.5 in order to use it as host. I configured eth0 with the vlan of the management network (Vlan 70). Then I registered the host to the engine (3.3.2-1-el6) and the engine installed oVirt in the host without problem. Ovirtmgmt was created automatically and bridged with eth0.70. Now I need to bond a second network interface (eth1) with eth0. But when I try to bond the nics, I get the next error: "A slave interface is not properly configured. Please verify slaves do not contain any of the following properties: network name, boot protocol, IP address, netmask, gateway or vlan-ID notation (as part of interface's name or explicitly)" I delete any unnecessary parameters from ifcfg-eth0 and ifcfg-eth1. This is my network config: ifcfg-eth0: DEVICE=eth0 TYPE=Ethernet ONBOOT=yes ifcfg-eth1: DEVIC E=eth1 TYPE=Ethernet ONBOOT=yes ifcfg-eth0.70: # Generated by VDSM version 4.13.2-1.el6 DEVICE=eth0.70 ONBOOT=yes VLAN=yes BRIDGE=ovirtmgmt NM_CONTROLLED=no STP=no ifcfg-ovirtmgmt: # Generated by VDSM version 4.13.2-1.el6 DEVICE=ovirtmgmt ONBOOT=yes TYPE=Bridge DELAY=0 IPADDR=192.168.1.101 NETMASK=255.255.255.0 BOOTPROTO=none DEFROUTE=yes NM_CONTROLLED=no STP=no No others ifcfg-* files. I don't see the parameters that oVirt doesn't like. Any clue, workaround, bug report....? Thanks! Federico PD: Sorry for my basic english