----- Original Message -----
From: "Dan Kenigsberg" <danken@redhat.com> To: "Jason Brooks" <jbrooks@redhat.com> Cc: "Nicholas Kesick" <cybertimber2000@hotmail.com>, "oVirt Mailing List" <users@ovirt.org> Sent: Monday, September 23, 2013 1:23:28 PM Subject: Re: [Users] Unable to finish AIO 3.3.0 - VDSM
On Mon, Sep 23, 2013 at 03:29:10PM -0400, Jason Brooks wrote:
Hi Nicholas, I just installed an F19 AIO without any problem. My install was only minimal, though. I restored my snapshot to pre-ovirt install and added the "standard" group, rebooted, installed, and vdsm still installed normally.
I'm wondering if it makes a difference if the system starts out with minimal+standard, rather than starting out minimal and adding standard after...
This is with dhcp addressing.
Another difference -- my AIO machine has nics w/ the regular eth0 naming -- don't know if the biosdevname bits could be causing an issue...
Would I be wrong to assume that you had /etc/sysconfig/network-scripts/ifcfg-eth0 defined before installation began?
My systems do always have this defined before installation begins. I almost always do PXE installs of Fedora. Wonder how it differs from a DVD install... Jason