5:22 p.m.
This is a multi-part message in MIME format.
--------------CA6FA101A23C7121C82BF9C5
Content-Type: text/plain; charset=utf-8; format=flowed
Content-Transfer-Encoding: 7bit
I have a rather strange issue which is affecting one of my last deployed
Hypervisors. It is a CentOS 7 (not a oVirt Node) which runs only 3
Virtual Machines.
One of these VMs have a reasonable output traffic at peaks (500 -
700Mbps) and the hypervisor underneath is connected to the switch via a
bonding (mode=2) which in turn creates bond0.XX interfaces which are
connected to different bridges for each network. The VM in question is
connected to bridge "ovirtmgmt".
When the problem happens the VM stops passing traffic and cannot reach
even the router or other VMs in the same Layer 2. Seems the bridge stop
passing traffic for that particular VM. Other VMs work fine since they
were created. When this problem happens I just need to go to its Console
and run a reboot (Ctrl-Alt-Del), don't even need to Power Off and Power
On again using oVirt Engine.
I have even re-installed this VMs operating system from scratch but the
problem persists. Have also changed the vNic mac address in the case
(already check) of conflicted mac addresses somewhere in that Layer 2.
Last, my hypervisor machine (due a mistake) has been running with
SElinux disabled, not sure if it could have anything to do with this
behavior.
Anyway, anyone has ever seen any behavior like that ?
Thanks
Fernando
--------------CA6FA101A23C7121C82BF9C5
Content-Type: text/html; charset=utf-8
Content-Transfer-Encoding: 7bit
<html>
<head>
<meta http-equiv="content-type" content="text/html;
charset=utf-8">
</head>
<body bgcolor="#FFFFFF" text="#000000">
<font face="arial, helvetica, sans-serif">I have a rather strange
issue which is affecting one of my last deployed Hypervisors. It
is a CentOS 7 (not a oVirt Node) which runs only 3 Virtual
Machines.<br>
<br>
One of these VMs have a reasonable output traffic at peaks (500 -
700Mbps) and the hypervisor underneath is connected to the switch
via a bonding (mode=2) which in turn creates bond0.XX interfaces
which are connected to different bridges for each network. The VM
in question is connected to bridge "ovirtmgmt".<br>
<br>
When the problem happens the VM stops passing traffic and cannot
reach even the router or other VMs in the same Layer 2. Seems the
bridge stop passing traffic for that particular VM. Other VMs work
fine since they were created. When this problem happens I just
need to go to its Console and run a reboot (Ctrl-Alt-Del), don't
even need to Power Off and Power On again using oVirt Engine.<br>
I have even re-installed this VMs operating system from scratch
but the problem persists. Have also changed the vNic mac address
in the case (already check) of conflicted mac addresses somewhere
in that Layer 2.<br>
<br>
Last, my hypervisor machine (due a mistake) has been running with
SElinux disabled, not sure if it could have anything to do with
this behavior.<br>
<br>
Anyway, anyone has ever seen any behavior like that ?<br>
<br>
Thanks<br>
Fernando<br>
</font>
</body>
</html>
--------------CA6FA101A23C7121C82BF9C5--