On 02/01/2012 07:23 AM, Dave Allan wrote: >I just installed the engine and a few nodes from RPMs all on F16 per >the instructions at: > >http://www.ovirt.org/wiki/Installing_ovirt-engine_from_rpm > >After installing the engine, I installed a few nodes by installing the >minimal F16 package set + wget, configuring the ovirt repo on the >nodes and using the 'New' button in the hosts tab of the engine GUI. >The installation went fine, but after the nodes rebooted they were >listed as non-reponsive. It turned out that VDSM was failing to start >because iscsid was failing to start. I turned up the debug level on >iscsid but didn't find any culprit. Manually force-starting iscsid >and then manually starting the vdsm service caused the nodes to change >status to Up. Anybody seen this or have any thoughts about what might >be wrong? > >Dave >_______________________________________________ >Users mailing list >Users(a)ovirt.org >http://lists.ovirt.org/mailman/listinfo/users https://bugzilla.redhat.com/show_bug.cgi?id=786174

Moran.