Thank you for your answer! I don't understand way I have to put them in replicate mode. As I understand replicate means, that the files get copy to both nodes, but I would like to have them independent, and I move the vm disks to the node how i want it. Theoretical I only need a solution where I can use local storage from the nodes, but that they are reachable over the network.  Jonathan 2017-11-09 11:39 GMT+01:00 Johan Bernhardsson <johan(a)kafit.se&gt;: > For it to work you need to have the bricks in replicate. Of brick > on each server.  > > If you only have two nodes. The quoum will be to low so it will set > the gluster to failsafe mode until the other brick comes online.  > > For it to work properly you need three nodes with one brick or two > nodes and a third node acting as an arbiter. > > /Johan > > On Thu, 2017-11-09 at 11:35 +0100, Jon bae wrote: > > Hello, > > I'm very new to oVirt and glusterFS, so maybe I got something > > wrong... > > > > I have the oVirt engine installed on a separate server and I have > > also two physical nodes. On every node I configure glusterFS, the > > volume is in distribution mode and have only one brick, from is > > one node. Both volumes I also add to its own storage domain. > > > > The idea was, that both storage domains are independent from each > > other, that I can turn of one node and only turn it on, when I > > need it. > > > > But now I have the problem, that when I turn of on node, both > > storage domains goes down. and the volume shows the the brick is > > not available. > > > > Is there a way to fix this? > > > > Regards > > Jonathan > > > > > > _______________________________________________ > > Users mailing list > > Users(a)ovirt.org > > http://lists.ovirt.org/mailman/listinfo/users > _______________________________________________ > Users mailing list > Users(a)ovirt.org > http://lists.ovirt.org/mailman/listinfo/users >