Re: [ovirt-users] workflow node installation

On 05/26/2014 04:15 AM, Fabian Deutsch wrote:
Am Sonntag, den 25.05.2014, 09:01 -0400 schrieb Doron Fediuck:
Don't we have ovirtmgmt defined by default during the registration process?
Hey,
IIRC that is done by ovirt-host-deploy during the registration, yes.
- fabian
----- Forwarded Message -----
From: "Jorick Astrego" <j.astrego@netbulae.eu> To: "users" <users@ovirt.org> Sent: Monday, May 19, 2014 1:11:58 PM Subject: [ovirt-users] workflow node installation
Hi,
I don't know if I'm doing things wrong but the workflow for node installation is a bit cumbersome for me.
The things I have to do to get a node up in ovirt engine:
- install node image from pxe - approve node - put node into maintenance mode (storage not available) - Setup Host Networks - Sync network (otherwise I cannot save the network changes) - Setup Host Networks again - Save Network setup - activate node
This seems problematic to me -- the host networks should be automatically set when you approve the node joining a given cluster.
Are you setting up the host networks on the engine side, or do you have to approve, log back into the node, configure networking, etc?
And this I have to do for every node. It could save me some time if I could setup the networks on approval or engine puts it directly into maintenance mode without the sync requirement.
Kind regards,
Jorick Astrego Netbulae B.V.
_______________________________________________ Users mailing list Users@ovirt.org http://lists.ovirt.org/mailman/listinfo/users

On 05/27/2014 06:25 PM, Ryan Barry wrote:
On 05/26/2014 04:15 AM, Fabian Deutsch wrote:
Am Sonntag, den 25.05.2014, 09:01 -0400 schrieb Doron Fediuck:
Don't we have ovirtmgmt defined by default during the registration process?
Hey,
IIRC that is done by ovirt-host-deploy during the registration, yes.
- fabian
----- Forwarded Message -----
From: "Jorick Astrego" <j.astrego@netbulae.eu> To: "users" <users@ovirt.org> Sent: Monday, May 19, 2014 1:11:58 PM Subject: [ovirt-users] workflow node installation
Hi,
I don't know if I'm doing things wrong but the workflow for node installation is a bit cumbersome for me.
The things I have to do to get a node up in ovirt engine:
- install node image from pxe - approve node - put node into maintenance mode (storage not available) - Setup Host Networks - Sync network (otherwise I cannot save the network changes) - Setup Host Networks again - Save Network setup - activate node
This seems problematic to me -- the host networks should be automatically set when you approve the node joining a given cluster.
Are you setting up the host networks on the engine side, or do you have to approve, log back into the node, configure networking, etc?
Everything from the engine side, we would like to deploy all the servers without manual intervention as much as possible so we don't have to login to the nodes at all. Preferably we disable local login completely for security purposes. ovirtmgmt works fine but I have two iSCSI networks and a separate internet network that are all set to required network.
And this I have to do for every node. It could save me some time if I could setup the networks on approval or engine puts it directly into maintenance mode without the sync requirement.
Kind regards,
Jorick Astrego Netbulae B.V.
_______________________________________________ Users mailing list Users@ovirt.org http://lists.ovirt.org/mailman/listinfo/users
participants (2)
-
Jorick Astrego
-
Ryan Barry