Thanks Strahil, for your suggestions. Actually, I was far beyond the pick-up point you describe, as the Gluster had all been prepared and was operable, even the local VM was already running and accessible via the GUI. But I picked up your hint to try to continue with the scripted variant, and found that it allowed me much better insight into what was going on. I am a little worried, though, that it actually works a little differently from the GUI-wizard variant, in any case the failures don't seem identical. That would have implications in terms of test-automation, which I'd rather not have to worry about. In a separate test for the same operation on a separate set of hardware the installation got significantly further, up to the point where the local VM had actually been moved onto the Gluster storage and into the Cluster, but then failed a validation step at the very end (while the VM is actually up and running, albeit only withe primary host and that listed as "Unresponsive" while it's hosting the VM....) I have opened a separate tickt for that... _______________________________________________ Users mailing list -- users(a)ovirt.org To unsubscribe send an email to users-leave(a)ovirt.org Privacy Statement: https://www.ovirt.org/site/privacy-policy/ oVirt Code of Conduct: https://www.ovirt.org/community/about/community-guidelines/ List Archives: https://lists.ovirt.org/archives/list/users@ovirt.org/message/FTCFIP7Q5KW...