Hi,

I have a CentOS 7.5 system running the oVirt-Engine package as the manager for three oVirt Nodes (version 4.2). Two of the nodes have a 200GB disk and one has a 2GB disk. I am attempting to create a Gluster Volume that replicates between the two 200GB disks with the 2GB as Arbiter.

When I create the bricks by going to Hosts > host1 > Storage Devices > Create Brick (with the 200GB device selected), it succeeds, but no bricks appear under the Bricks tab for the Host. Doing the same for host2 and host3 results in the same problem.

After creating the brick from the UI can you try clicking on sync once and wait for the notification.

If I run the following command on a host `gluster volume create test-volume replica 3 arbiter 1 192.168.5.{50,60,40}:/gluster-bricks/200GBbrick/test`, it creates the volume correctly and the bricks then appear as they should. However, then these Bricks are labeled as "Down" and when I go to Storage > Volumes, I get this error: ``` Uncaught exception occurred. Please try reloading the page. Details: (TypeError) : Cannot read property 'a' of null Please have your administrator check the UI logs ``` The Volume is also shown as "Down". SELinux is enabled on my CentOS 7.5 system.

I'm not really sure what the correct method is to create bricks then a Volume in Gluster through the oVirt Management UI, but I've followed the guides and this is where it has got me.

Thanks, Kaustav