[Engine-devel] ovirt-host-deploy and multible bridges

[Sahina Bose]

[Adding vdsm-devel]

On 04/09/2013 03:40 PM, Sahina Bose wrote:
> Hi all,
>
> I'm testing the bootstrapping of host without reboot on Fedora 18. After
> host's bootstrap,
> Ifconfig output returns this:
>
> ovirtmgmt: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
>           inet 10.70.37.219  netmask 255.255.254.0  broadcast 10.70.37.255
>     <snipped>
>
> virbr0: flags=4099<UP,BROADCAST,MULTICAST>  mtu 1500
>           inet 192.168.122.1  netmask 255.255.255.0  broadcast
> 192.168.122.255
>          <snipped>
>
> Running*glusterHostsList*  vdsm verb, returns the ip address
> 192.168.122.1, whereas my host has been added with ip address 10.70.37.219
>
> If I reboot the host, the virbr0 bridge is removed, and there's no issue.
>
> The vdsm verb glusterHostsList - returns ipAddress of host + output of 
> gluster peer probe. This is needed because a periodic sync job needs 
> to make sure that the hosts added in engine are in sync with the 
> gluster cli (hosts could also be added/removed from gluster cli).
>
> How can we make sure glusterHostsList picks the correct ipAddress? 
> Reading the inetinfo based on bridge has been vetoed as we are doing 
> away with bridges.
>
> It would also work if virbr0 was updated in vds_interfaces table. 
> Since this is not happening either - we have an issue.
>
> thanks
> sahina
>
>
>
> _______________________________________________
> Engine-devel mailing list
> Engine-devel at ovirt.org
> http://lists.ovirt.org/mailman/listinfo/engine-devel

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.ovirt.org/pipermail/engine-devel/attachments/20130409/d01d4bdb/attachment.html>