[Engine-devel] ovirt-host-deploy and multible bridges

[Sahina Bose]

Hi all,

I'm testing the bootstrapping of host without reboot on Fedora 18. After
host's bootstrap,
Ifconfig output returns this:

ovirtmgmt: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
          inet 10.70.37.219  netmask 255.255.254.0  broadcast 10.70.37.255
    <snipped>

virbr0: flags=4099<UP,BROADCAST,MULTICAST>  mtu 1500
          inet 192.168.122.1  netmask 255.255.255.0  broadcast
192.168.122.255
         <snipped>

Running*glusterHostsList*  vdsm verb, returns the ip address
192.168.122.1, whereas my host has been added with ip address 10.70.37.219

If I reboot the host, the virbr0 bridge is removed, and there's no issue.

The vdsm verb glusterHostsList - returns ipAddress of host + output of 
gluster peer probe. This is needed because a periodic sync job needs to 
make sure that the hosts added in engine are in sync with the gluster 
cli (hosts could also be added/removed from gluster cli).

How can we make sure glusterHostsList picks the correct ipAddress? 
Reading the inetinfo based on bridge has been vetoed as we are doing 
away with bridges.

It would also work if virbr0 was updated in vds_interfaces table. Since 
this is not happening either - we have an issue.

thanks
sahina

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.ovirt.org/pipermail/engine-devel/attachments/20130409/e9f7379b/attachment.html>