[node-devel] oVirt Node 2.4.0 Posted

[Mike Burns]

On Thu, 2012-06-14 at 18:50 +0200, Dennis Jacobfeuerborn wrote:
> On 06/14/2012 03:25 PM, Mike Burns wrote:
> > The image is posted to the beta area on ovirt.org[1].  There will likely
> > be a 2.4.1 release in the next couple weeks as we clean up some other
> > issues.
> 
> I just did a test install and this is the result so far:
> 
> When booting the iso itself and the installed node later I get the
> following output:
> rpcbind: rpcbind terminating on signal. Restart with "rpcbind -w"
> the boot process continues though.
> 
> I can't seem to configure the network. When I move to "eth0" and hit enter
> I see a blue screen for about 20 seconds and then I get back to the grey
> background with header and footer but nothing in the content area. Hitting
> a cursor key the menu appears but in the top left corner instead of where
> it's supposed to be. Selecting anything doesn't change the content are
> though. When I hit f12 the gui apparently resets and everything looks
> alright again.
> 

Argh,  we were seeing this in builds just before the official one.
There was a patch that fixed it that was apparently missed int the
build.  I'm respinning a new 2.4.0 build now (2.4.0-1 actually).

Mike


> Looking at the logs I see
> ovirtfunctions - unable to determine ip/netmask from:
> ovirtfunctions - unable to determine ip/netmask from: Device "breth0" does
> not exist.
> 
> Is there a manual way to configure the networking so I can test the engine
> connection?
> 
> Regards,
>   Dennis
> _______________________________________________
> node-devel mailing list
> node-devel at ovirt.org
> http://lists.ovirt.org/mailman/listinfo/node-devel