[node-devel] oVirt Node 2.4.0-1 Posted

[Dennis Jacobfeuerborn]

Thanks! With the new iso I can successfully configure the network.
When I try to register the node with the engine I get the same problem
though. I select "oVirt Engine", enter the IP of the engine system and hit
apply and get the same menu problem as with the Network option before.

Regards,
  Dennis

On 06/14/2012 07:58 PM, Mike Burns wrote:
> 2.4.0-1 is now posted in the same place as 2.4.0.  It includes a fix for
> the network screen not working correctly (patch was merged, but was
> missing from my repo when I built).
> 
> Mike
> 
> On Thu, 2012-06-14 at 13:10 -0400, Mike Burns wrote:
>> On Thu, 2012-06-14 at 18:50 +0200, Dennis Jacobfeuerborn wrote:
>>> On 06/14/2012 03:25 PM, Mike Burns wrote:
>>>> The image is posted to the beta area on ovirt.org[1].  There will likely
>>>> be a 2.4.1 release in the next couple weeks as we clean up some other
>>>> issues.
>>>
>>> I just did a test install and this is the result so far:
>>>
>>> When booting the iso itself and the installed node later I get the
>>> following output:
>>> rpcbind: rpcbind terminating on signal. Restart with "rpcbind -w"
>>> the boot process continues though.
>>>
>>> I can't seem to configure the network. When I move to "eth0" and hit enter
>>> I see a blue screen for about 20 seconds and then I get back to the grey
>>> background with header and footer but nothing in the content area. Hitting
>>> a cursor key the menu appears but in the top left corner instead of where
>>> it's supposed to be. Selecting anything doesn't change the content are
>>> though. When I hit f12 the gui apparently resets and everything looks
>>> alright again.
>>>
>>
>> Argh,  we were seeing this in builds just before the official one.
>> There was a patch that fixed it that was apparently missed int the
>> build.  I'm respinning a new 2.4.0 build now (2.4.0-1 actually).
>>
>> Mike
>>
>>
>>> Looking at the logs I see
>>> ovirtfunctions - unable to determine ip/netmask from:
>>> ovirtfunctions - unable to determine ip/netmask from: Device "breth0" does
>>> not exist.
>>>
>>> Is there a manual way to configure the networking so I can test the engine
>>> connection?
>>>
>>> Regards,
>>>   Dennis
>>> _______________________________________________
>>> node-devel mailing list
>>> node-devel at ovirt.org
>>> http://lists.ovirt.org/mailman/listinfo/node-devel
>>
>>
>> _______________________________________________
>> node-devel mailing list
>> node-devel at ovirt.org
>> http://lists.ovirt.org/mailman/listinfo/node-devel
> 
>