[node-devel] oVirt Node 2.4.0-1 Posted

[Mike Burns]

On Thu, 2012-06-14 at 23:32 +0200, Dennis Jacobfeuerborn wrote:
> Thanks! With the new iso I can successfully configure the network.
> When I try to register the node with the engine I get the same problem
> though. I select "oVirt Engine", enter the IP of the engine system and hit
> apply and get the same menu problem as with the Network option before.
> 
> Regards,
>   Dennis

Hi Dennis,

I've had another report of the same issue [1].  It's being investigated
now.

Mike


[1] https://bugzilla.redhat.com/show_bug.cgi?id=832196

> 
> On 06/14/2012 07:58 PM, Mike Burns wrote:
> > 2.4.0-1 is now posted in the same place as 2.4.0.  It includes a fix for
> > the network screen not working correctly (patch was merged, but was
> > missing from my repo when I built).
> > 
> > Mike
> > 
> > On Thu, 2012-06-14 at 13:10 -0400, Mike Burns wrote:
> >> On Thu, 2012-06-14 at 18:50 +0200, Dennis Jacobfeuerborn wrote:
> >>> On 06/14/2012 03:25 PM, Mike Burns wrote:
> >>>> The image is posted to the beta area on ovirt.org[1].  There will likely
> >>>> be a 2.4.1 release in the next couple weeks as we clean up some other
> >>>> issues.
> >>>
> >>> I just did a test install and this is the result so far:
> >>>
> >>> When booting the iso itself and the installed node later I get the
> >>> following output:
> >>> rpcbind: rpcbind terminating on signal. Restart with "rpcbind -w"
> >>> the boot process continues though.
> >>>
> >>> I can't seem to configure the network. When I move to "eth0" and hit enter
> >>> I see a blue screen for about 20 seconds and then I get back to the grey
> >>> background with header and footer but nothing in the content area. Hitting
> >>> a cursor key the menu appears but in the top left corner instead of where
> >>> it's supposed to be. Selecting anything doesn't change the content are
> >>> though. When I hit f12 the gui apparently resets and everything looks
> >>> alright again.
> >>>
> >>
> >> Argh,  we were seeing this in builds just before the official one.
> >> There was a patch that fixed it that was apparently missed int the
> >> build.  I'm respinning a new 2.4.0 build now (2.4.0-1 actually).
> >>
> >> Mike
> >>
> >>
> >>> Looking at the logs I see
> >>> ovirtfunctions - unable to determine ip/netmask from:
> >>> ovirtfunctions - unable to determine ip/netmask from: Device "breth0" does
> >>> not exist.
> >>>
> >>> Is there a manual way to configure the networking so I can test the engine
> >>> connection?
> >>>
> >>> Regards,
> >>>   Dennis
> >>> _______________________________________________
> >>> node-devel mailing list
> >>> node-devel at ovirt.org
> >>> http://lists.ovirt.org/mailman/listinfo/node-devel
> >>
> >>
> >> _______________________________________________
> >> node-devel mailing list
> >> node-devel at ovirt.org
> >> http://lists.ovirt.org/mailman/listinfo/node-devel
> > 
> > 
> 
> _______________________________________________
> node-devel mailing list
> node-devel at ovirt.org
> http://lists.ovirt.org/mailman/listinfo/node-devel