[Users] [vdsm] Remove and Add host does not work

[Itamar Heim]

On 02/28/2012 03:22 PM, Deepak C Shetty wrote:
> On 02/28/2012 06:46 PM, Itamar Heim wrote:
>> On 02/28/2012 02:48 PM, Deepak C Shetty wrote:
>>> Hi,
>>> I had a host managed via OE, completely working fine. Was even able to
>>> create and run VMs off it.
>>> I tried removing the host from the OE (put host into maint. mode and
>>> then remove) and when i re-discover
>>> the same host, OE just keeps seeing it as Non-responsive.
>>
>> what do you mean by "re-discover"?
>>
>
> I just meant that i removed the host and re-added it by selecting "New"
> on the Hosts tab
> and putting the IP and hostname.
>
>>>
>>> I am able to ssh into the host and see that none of the vdsm processes
>>> have been started.
>>> I tried doing "Confirm host has been rebooted" on the OE, did not help.
>>> I tried putting
>>> host into maint. mode and re-activating the host, just doesn't help
>>
>> did you do any change to the host?
>> just removing it from engine shouldn't cause vdsm to know/care and
>> should work just like before.
>>
>
> Nothing changed on the host. In fact when i removed and added the host back
> it says everything is installed so does nothing but reboots the host,
> post reboot
> vdsm does not start automatically.... and host status is non-responsive
> on OE

if vdsm does not start, OE is correct...
does vdsm try to start and fails (and if so, log excerpt?)