[Users] SSL error when adding host (oVirt 3.1)

[Itamar Heim]

On 07/09/2012 10:59 PM, Justin Clift wrote:
> On 10/07/2012, at 5:53 AM, Itamar Heim wrote:
> <snip>
>>> Installation was performed from F17 using the "from rpm" instructions here:
>>>
>>>   http://www.ovirt.org/wiki/Installing_VDSM_from_rpm
>>>
>>> _Guessing_ the "ssl = false" bit is causing the problem.  No idea how to
>>> either enable ssl in the host, or turn it off in Engine though. (or anything
>>> else that works :>)
>>
>> why would you have ssl = false anywhere?
>
>
> That's what the above steps in the "Installing VDSM from rpm" instructions
> say to do.  My understanding of the pieces in oVirt isn't yet great enough
> to do stuff _without_ following instructions yet. ;)

are you installing them both on same host?
"this (these) steps are usually not required when installing VDSM on 
another host than ovirt-engine"

if you do want on same host, this is old and should probably be 
superseded by:
http://www.ovirt.org/wiki/Feature/AllInOne
(not sure has a wiki on how to use, but basically you just need to 
install the allinon setup plugin rpm adn run installer