[Users] vdsm issue

Jason Brooks jbrooks at redhat.com
Thu Mar 1 18:50:48 UTC 2012


I wonder about that dirty yum upgrade bit -- I upgraded a remote F15
server to F16 yesterday using preupgrade-cli and then went on to
configure that server as engine+host as you're doing. It worked fine.

On 03/01/2012 10:41 AM, Michal Kopacki wrote:
> --------------------------------------------------------------
> On 2012-03-01 17:42:42 , Itamar Heim (iheim at redhat.com) wrote:
>>
>> not sure about the error below, but installing vdsm requires more
>> configuration done by engine when you choose to add a host.
>      I'm not sure what you mean by "more configuration". As I understand
> after install of vdsm it will be started as a service which apparently
> is not going well.
>> can you try adding the host via the engine (it will reboot in the last
>> phase...).
>      It's exactly what I did. After vsdm install I went to ovirt-engine
> page and add host (localhost in this case). In event window i saw that
> there are components installing and after reboot i can see information
> as below:
> 
> "This host is in non responding state. Try to Activate it; If the
> problem persists, switch Host to Maintenance mode and try to reinstall it."
> 
> Of course Activate solves nothing.
> 




More information about the Users mailing list