[Users] vdsm issue

[Michal Kopacki]

On Fri, 2 Mar 2012 02:06:15 +0200
Itamar Heim <iheim at redhat.com> wrote:

> On 03/01/2012 08:41 PM, Michal Kopacki wrote:
> > --------------------------------------------------------------
> > On 2012-03-01 17:42:42 , Itamar Heim (iheim at redhat.com) wrote:
> >>
> >> not sure about the error below, but installing vdsm requires more
> >> configuration done by engine when you choose to add a host.
> > I'm not sure what you mean by "more configuration". As I understand
> > after install of vdsm it will be started as a service which
> > apparently is not going well.
> >> can you try adding the host via the engine (it will reboot in the
> >> last phase...).
> > It's exactly what I did. After vsdm install I went to ovirt-engine
> > page and add host (localhost in this case). In event window i saw
> > that there are components installing and after reboot i can see
> > information as below:
> >
> > "This host is in non responding state. Try to Activate it; If the
> > problem persists, switch Host to Maintenance mode and try to
> > reinstall it."
> >
> > Of course Activate solves nothing.
> >
> 
> how did you add the host (did you use fqdn?)

  I did this using ip address and I'm sure it's not the issue here - I
    have done this exactly same on different engine host and it is fine.

-- 
Michal