[Users] simple networking? [SOLVED] mostly
Juan Pablo Lorier
jplorier at gmail.com
Mon Dec 16 19:22:32 UTC 2013
Here's the vdsm.log that should match the one I just sent to Antoni.
I can't be much of help these days (I'm out of office), but if it's just
send logs, I'll be back at office next friday and give you the info you
On 16/12/13 17:09, Moti Asayag wrote:
> ----- Original Message -----
>> From: "Juan Pablo Lorier" <jplorier at gmail.com>
>> To: users at ovirt.org
>> Sent: Monday, December 16, 2013 7:54:34 PM
>> Subject: Re: [Users] simple networking? [SOLVED] mostly
>> I have the same problem and already have mentioned that in previous
>> posts. In my case, I have vlan 128 tagged assigned for ovirtmgmt so I
>> set the host ip manually on top of a vlan interface and the, after ovirt
>> does install the node, it fails to finish as it can't manage properly to
>> create the bridge and pass the ip to the brand new bridge. The ovirtmgmt
>> interface I create in engine is a bond (and originally I configure just
>> a single interface with the ip to grant engine access), just in case
>> this changes the scenario.
> Just to make sure i get it right:
> You're attempting to install a host which is configured:
> eth0 --- eth0.128 (which has a static ip configured)
> When you install the host, you provide as address either the ip of eth0.128
> as you configured manually or a fqdn which is resolved to the same ip.
> 'ovirtmgmt' logical network definition is a vm network tagged with 128.
> Can you provide the from the output of 'getCapabilities' from the vdsm.log
> immediately after vdsm starts during the installation the value of 'lastClientIface' ?
> Or even better - the entire output of 'getCapabilities' (which will indicate that
> vdsm reports properly the required information about the nic it should configure).
> Could you confirm the above and provide the missing pieces ?
>> Users mailing list
>> Users at ovirt.org
More information about the Users