[Users] What parameters to use in automated node install to enable engine CLI register?

[David Li]

Hi Itamar,

I am not sure I understand the question.
How can I see the node from over-shell CLI if it's not connected to it?  Are you refering to some CLI cmd that allows me to do this?

David



>________________________________
> From: Itamar Heim <iheim at redhat.com>
>To: David Li <david_li at sbcglobal.net>; "users at ovirt.org" <users at ovirt.org> 
>Sent: Wednesday, December 18, 2013 1:17 AM
>Subject: Re: [Users] What parameters to use in automated node install to enable engine CLI register?
> 
>
>On 12/17/2013 05:59 PM, David Li wrote:
>> Hi,
>>
>>
>> My node install followed the automatic install instructions in
>>
>> https://access.redhat.com/site/documentation/en-US/Red_Hat_Enterprise_Virtualization/3.0/html/Hypervisor_Deployment_Guide/sect-Deployment_Guide-Installing_Red_Hat_Enterprise_Virtualization_Hypervisors-RHEV_Hypervisor_Kernel_Parameters_and_Automated_Installation.html
>>
>>
>> For the kernel boot parameters, I used
>>
>> management_server=<my machine IP running ovirt-shell CLI>
>> rhevm_admin_password=xyz
>>
>
>do you see the node in pending approval state in the engine?'
>
>
>> However I see a few problems when I tried to use ovirt-shell CLI to
>> connect to the engine.
>>
>> [oVirt shell (disconnected)]# connect --url "http://<node-IP>:8080/api"
>> --username "admin" --password "xyz"
>
>ovirt-shell is to engine to approve the node, not to node directly.
>
>>
>>
>> 1. Though I can ping the node, but this cmd gave errors: error: [Errno
>> 113] No route to host
>> 2. What should I use for "--username" argument?  What is "@domain"?
>>
>> David
>>
>>
>>
>>
>> _______________________________________________
>> Users mailing list
>> Users at ovirt.org
>> http://lists.ovirt.org/mailman/listinfo/users
>>
>
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.ovirt.org/pipermail/users/attachments/20131218/cb553b8c/attachment-0001.html>