[Users] how to configure reports

[Yaniv Dary]

We are getting very close to provide packaging for reports in upstream and it will be in for oVirt 3.3.
DWH packaging is ready and you can clone the repo and make a rpm for the main directory.



Yaniv

----- Original Message -----
> From: "Itamar Heim" <iheim at redhat.com>
> To: "Gianluca Cecchi" <gianluca.cecchi at gmail.com>
> Cc: "users" <users at ovirt.org>, "Yaniv Dary" <ydary at redhat.com>
> Sent: Tuesday, February 5, 2013 12:40:49 PM
> Subject: Re: [Users] how to configure reports
> 
> On 05/02/2013 12:09, Gianluca Cecchi wrote:
> > Hello,
> > no setup done yet on 3.2 beta for reports.
> > On oVirt site I find these references
> > http://www.ovirt.org/Ovirt_Reports
> > and
> > http://www.ovirt.org/How_to_setup_a_oVirt_Reports_development_environment
> >
> > but I've not understood what features are available and how to
> > setup
> >
> > when I access the reports link I get:
> >
> > Page: Reports is not a leagal.
> >
> >  From an rhev 3.1 point of vew the steps should be:
> >
> > yum install rhevm-dwh (for only DWH)
> > or
> > yum install rhevm-reports (for both DWH and reports)
> >
> > rhevm-dwh-setup
> > (that btw restarts the ovirt-engine service)
> >
> > rhevm-reports-setup
> > (that btw restarts the ovirt-engine service)
> >
> > Does this map in any way to oVirt if applicable for 3.2 beta?
> >
> 
> report packaging for ovirt is still in progress. yaniv may be able to
> provide a more current status
> 
> 
>