[Users] 3.1 and centos 6.3 problem

[Fernando Ariel Martinez]

I could see that the volume (vol1) was mounted with nfs type.
I dismounted the volume and mounted it again in both nodes but using
glusterfs type.

This time, I could create a 10GB preallocated virtual disk.
The events tab showed:
2013-Feb-19, 09:12:39 Add-Disk operation of 'vm1_Disk1' was initiated on
VM vm1 by admin at internal.
2013-Feb-19, 09:30:35 The disk 'vm1_Disk1' was successfully added to VM vm1.

Too slow, isn't? but worked


El 19/02/2013 08:21 a.m., Fernando Ariel Martinez escribió:
> I have installed ovirt 3.1 according to the instructions in "Integrating
> Gluster storage into oVirt" - by Robert Middleswarth, linked in
> http://wiki.ovirt.org/Documentation.
> I was able to complete the instructions successfully but I have problems
> when a need to create a VM. Especifically when I need to allocate space
> for the virtual disk.
>
> I have:
> 1 ovirt engine server, (admin)
> 2 nodes, IBM System x 3650M3 (nodo1, nodo2)
> 1 switch cisco SG 300-20 (to connect them)
>
> I created a VM (vm1).
> When I add a 10GB preallocated disk to vm1, after a few seconds the
> ovirt engine server loses the connection with the node SPM.
> I can see in the events tab "Invalid status on Data Center Default.
> Setting status to Non-Responsive."
> Then, the SPM changes to the other node. At last, in the events tab I
> can see "Operation Add-Disk failed to complete on VM vm1."
>
> I have set SELinux in permissive mode. I have also disabled iptables.
> In the ovirt engine server there are an ISO domain, called iso, (NFS
> Export Path: admin.cluster:/nfs/iso) and an Export domain, called exp,
> (NFS Export Path: admin.cluster:/nfs/export).
> In each node with gluster, the /data directory is used to create the
> volume vol1 (type: Replicate)
> The Data domain is called vms (NFS Export Path: localhost:/vol1).
>
> Some help wil be appreciated
>
> Fernando M.